Stuart Turner Submersible Diver 35 & 45 Boostamatic - Manual (Page 7)

- 7 -
MAINTENANCE
WARNINGS:
 Care should be taken to protect pump from frost and freezing.
Cleaners, disinfectants and descalents
On installations where chemical disinfectants or descalents are periodically
used, the compatibility of the chemical solution regarding the pump must be
considered.
Acid based descalents and aggressive cleaning agents must not come into
contact with the pump. The pump must be removed from the system prior to the
use of these products. The system should be flushed to remove all chemicals
before the pump is re-connected.
If in any doubt as to the suitability of the chemical solutions refer to Stuart
Turner Ltd.
STORAGE
If this product is not installed immediately on receipt, ensure that it is stored in a dry, frost
and vibration free location in its original packaging.
TROUBLE SHOOTING GUIDE
Symptoms Probable Cause Recommended Action
Pump will not start.
Control module failure
light illuminated. Liquid supply low. Check liquid level in the supply tank and all stopcocks are
open.
Reset the control module by depressing the restart button.
Inlet filter blocked
(if fitted). Remove and clean filter gauze.
Reset control unit.
Electrical supply. Check all electrical switches are on.
Is the correct fuse fitted?
Is the circuit breaker set?
Static inlet or outlet head
is greater than permitted. Re-position control module.
(See siting of the pump and limits of application section).