Stuart Turner Flomate Mains Boost - Manual (Page 2)

- 2 -
Cont ...
PRODUCT DESCRIPTION
Electric motor driven peripheral pump with bypass, complete with an automatic control
system consisting of flow switch and electronic control.
APPLICATION
The Flomate is a mains booster pump with an automatic control system for domestic
use, designed to assist the pressure from the mains supply, where the mains pressure is
insufficient. This unit requires a minimum unassisted supply flow of 0.6 l/min to operate.
The pump is limited to producing a maximum flow of not greater than 12 l/min, and a
maximum pressure of 3.0 bar.
When the flow/pressure from the rising main exceeds the pump output, the patented
applied for integral bypass will direct the water into the system as normal.
The Flomate mains booster is a patent applied for design.
Please note the following warning signs.
Warning of possible electrical hazard.

Possible danger to personnel or important installation requirement.
 All the safety and operating instructions in this booklet must be
followed.
 The pump must not be used for any other application without the
written consent of Stuart Turner Limited.
 The pump must be installed by a qualified person.

The pump is not suitable for heavy commercial/industrial applications.
 The installation must comply with the latest Building Regulations,
Wiring Regulations (BS 7671) and Water Supply Regulations (see
notes).

This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be made
by children without supervision.
 Children should be supervised to ensure that they do not play with the
appliance.
Notes
 This product must be installed in accordance with the current Water
Supply (Water Fittings) Regulations.
 Under no account should the internal flow restrictor be removed, or
replaced with an alternative design.