Stuart Turner Monsoon Extra S1.4 bar Single User Manual

Page 10

- 10 -

4.21

Wiring Diagrams:

Model

Fuse Size (AMPS)

Monsoon Extra S1.4 bar

4.22

Fuses: The following fuse size should be used with the appropriate pump:

4.23

Supply Cord Replacement:

The supply cord and internal wiring within the terminal box are
routed and secured to ensure compliance with the electrical
standard EN 60335-1. It is essential that prior to any disturbance
of this internal wiring, all cable routing and securing details are
carefully noted to ensure re-assembly to the same factory pattern
is always maintained.

If the supply cord is to be changed or is damaged, it must be replaced with a

special cord assembly available from Stuart Turner or one of their approved

repairers.

On disassembly note the cord retention and routing system. Re-assemble to the

same

pattern.

For information on cable connection consult the wiring diagram and cable gland

fitting

instructions.

4.24

Cable Gland Fitting Instructions:

To enable correct assembly of the cable gland the

‘O’-ring (Fig. 9 item 1) must be placed over the cable

before the clamping insert (Fig. 9 item 2) can be

tightened.

Note: Cable diameter range:- 6.5 mm to 9.5 mm.

4.25

Supply Cord Extension:

The pumps are fitted with a supply cord to the following

specification:-

All models . . . . . . . . . . . . . . . . . HO5VV-F3 G 0.75 mm² - 6 Amp rated cable.

If the supply cord is to be extended, a cord of the same specification should be

used. Any connections or junction boxes used should be specifically suited for

the application and installed in accordance with the manufacturers instructions.

Fig. 9

MAIN WINDING

THERMOTRIP

CAPACITOR

START WINDING

LIN

K WIRE (BLUE)

BROWN

BLA

GREEN/
YELLOW

BLUE

BROWN

S2 S3 S3 S2

FLOWSWITCH
REED (S3)

BLUE

Monsoon Extra S1.4 bar Single

Fig. 8