6mounting the cranks on the centering plate – MAHLE RTI BRC440 User Manual
Page 8
Page 6
6
Mounting the Cranks on the Centering Plate
6.1
A scribe mark (A) is located on each Crank and large nut. Turn the large
nut onto the Crank as far as possible, finger tight. The scribe mark
should be aligned on the large nut and the barrel of the Crank. Then,
loosen the large nut one full turn, once again aligning the scribe marks.
Do this on all Cranks.
6.2
Numbers (B) are stamped on the Centering Plate next to the holes for
mounting the Cranks. Mount four cranks in the holes numbered 4 for a
four-lug wheel. Mount five cranks in the holes numbered 5 for a five-lug
wheel. Mount three cranks in the holes numbered 3 for a six-lug wheel.
Insert the Cranks into the appropriate holes, install the washers, and
small nuts. Finger tighten the small nuts.
6.3
Position the legs (C) of all the Cranks so they point in the counter-
clockwise direction.
- NTO-200 (REV A) (16 pages)
- NTO-200 (7 pages)
- NTF-15H (1 page)
- NTF-15H (11 pages)
- NTF-230 (13 pages)
- NTF-230 (Rev B) (11 pages)
- NTF-15 (10 pages)
- NTF-15 (11 pages)
- NTF-515 (Rev A) (14 pages)
- ATX-2 (Rev B) (15 pages)
- ATX-2 (Rev B) (17 pages)
- ATX-2 (Rev C) (15 pages)
- ATX-2 (Rev D) (17 pages)
- ATX-2 (15 pages)
- ATX-2 (17 pages)
- ATX-2 (18 pages)
- ATX-2 (Rev A) (17 pages)
- PSX-2 (2 pages)
- ATX-3 (22 pages)
- MCX-1 (Rev A) (16 pages)
- MCX-1 (Rev D) (18 pages)
- MCX-1 (Rev E) (18 pages)
- MCX-2 (Rev A) (18 pages)
- MCX-2 (Rev B) (20 pages)
- MCX-2 (Rev C) (20 pages)
- MCX-2 (Rev D) (20 pages)
- MCX-2 (Rev E) (20 pages)
- MCX-2 (18 pages)
- MCX-2 (Rev F) (21 pages)
- MCX-2 (Rev F) (20 pages)
- MCX-2 (Rev G) (20 pages)
- MCX-2F (Rev A) (21 pages)
- MCX-2F (Rev C) (21 pages)
- MCX-2F (21 pages)
- MCX-2F (Rev D) (21 pages)
- MCX-2HD (20 pages)
- VCX-1 (16 pages)
- VCX-1 (17 pages)
- VCX-4 (17 pages)
- PSX-3 (1 page)
- DFX-1 (1 page)
- BFX-2 (12 pages)
- BFX-2 (13 pages)
- DCS-1 (2 pages)
- ELF-1 (14 pages)