MAHLE RTI BRC440 User Manual
Page 6
Page 4
4
Mounting of Hub & Centering Plate Storage Brackets
4.1
Place Square Nut (F) inside each leg and mount the Hub Arm
Storage Bracket (C) using Bolts and Washers (D-E). Position
the bracket as shown, noting that the ends are cut to match
the angle of each leg. Place plastic end cap into end of legs.
4.2
Mount the Centering Plate Bracket (L-M-N-O-P). Position
bracket at the top of the lower column of the Drive Stand. The
hook should face towards the Hub Arm Storage Bracket (C).
See also other documents in the category MAHLE RTI Accessories for air:
- NTO-200 (REV A) (16 pages)
- NTO-200 (7 pages)
- NTF-15H (1 page)
- NTF-15H (11 pages)
- NTF-230 (13 pages)
- NTF-230 (Rev B) (11 pages)
- NTF-15 (10 pages)
- NTF-15 (11 pages)
- NTF-515 (Rev A) (14 pages)
- ATX-2 (Rev B) (15 pages)
- ATX-2 (Rev B) (17 pages)
- ATX-2 (Rev C) (15 pages)
- ATX-2 (Rev D) (17 pages)
- ATX-2 (15 pages)
- ATX-2 (17 pages)
- ATX-2 (18 pages)
- ATX-2 (Rev A) (17 pages)
- PSX-2 (2 pages)
- ATX-3 (22 pages)
- MCX-1 (Rev A) (16 pages)
- MCX-1 (Rev D) (18 pages)
- MCX-1 (Rev E) (18 pages)
- MCX-2 (Rev A) (18 pages)
- MCX-2 (Rev B) (20 pages)
- MCX-2 (Rev C) (20 pages)
- MCX-2 (Rev D) (20 pages)
- MCX-2 (Rev E) (20 pages)
- MCX-2 (18 pages)
- MCX-2 (Rev F) (21 pages)
- MCX-2 (Rev F) (20 pages)
- MCX-2 (Rev G) (20 pages)
- MCX-2F (Rev A) (21 pages)
- MCX-2F (Rev C) (21 pages)
- MCX-2F (21 pages)
- MCX-2F (Rev D) (21 pages)
- MCX-2HD (20 pages)
- VCX-1 (16 pages)
- VCX-1 (17 pages)
- VCX-4 (17 pages)
- PSX-3 (1 page)
- DFX-1 (1 page)
- BFX-2 (12 pages)
- BFX-2 (13 pages)
- DCS-1 (2 pages)
- ELF-1 (14 pages)