11 attaching the drive motor – MAHLE RTI BRC440 User Manual
Page 14
Page 12
11 Attaching the Drive Motor
Note: The above shows a cut-away of the Hub Arm Assembly to illustrate the connection
between the Drive Motor Shaft and the Pin and Ball in the Hub Arm Assembly.
11.1
Adjust the Drive Motor Stand so the Motor Shaft (A) is aligned with the hole in the
Hub Arm Assembly.
11.2
Slide the Shaft (A) of the Drive Motor into the Hub Arm Assembly. It may be
necessary to turn the shaft to align the slot in the end fitting with the pin (B) in the
Hub Arm Assembly.
11.3
Push the Drive Motor Shaft into the Hub Arm Assembly until the Ball (C) is felt
snapping into the indent in the fitting on the end of the shaft.
See also other documents in the category MAHLE RTI Accessories for air:
- NTO-200 (REV A) (16 pages)
- NTO-200 (7 pages)
- NTF-15H (1 page)
- NTF-15H (11 pages)
- NTF-230 (13 pages)
- NTF-230 (Rev B) (11 pages)
- NTF-15 (10 pages)
- NTF-15 (11 pages)
- NTF-515 (Rev A) (14 pages)
- ATX-2 (Rev B) (15 pages)
- ATX-2 (Rev B) (17 pages)
- ATX-2 (Rev C) (15 pages)
- ATX-2 (Rev D) (17 pages)
- ATX-2 (15 pages)
- ATX-2 (17 pages)
- ATX-2 (18 pages)
- ATX-2 (Rev A) (17 pages)
- PSX-2 (2 pages)
- ATX-3 (22 pages)
- MCX-1 (Rev A) (16 pages)
- MCX-1 (Rev D) (18 pages)
- MCX-1 (Rev E) (18 pages)
- MCX-2 (Rev A) (18 pages)
- MCX-2 (Rev B) (20 pages)
- MCX-2 (Rev C) (20 pages)
- MCX-2 (Rev D) (20 pages)
- MCX-2 (Rev E) (20 pages)
- MCX-2 (18 pages)
- MCX-2 (Rev F) (21 pages)
- MCX-2 (Rev F) (20 pages)
- MCX-2 (Rev G) (20 pages)
- MCX-2F (Rev A) (21 pages)
- MCX-2F (Rev C) (21 pages)
- MCX-2F (21 pages)
- MCX-2F (Rev D) (21 pages)
- MCX-2HD (20 pages)
- VCX-1 (16 pages)
- VCX-1 (17 pages)
- VCX-4 (17 pages)
- PSX-3 (1 page)
- DFX-1 (1 page)
- BFX-2 (12 pages)
- BFX-2 (13 pages)
- DCS-1 (2 pages)
- ELF-1 (14 pages)