MAHLE RTI TechAlert - Manual (Page 10)

9
SYNCHRONIZATION (Continued)
Checking the Remote for Synchronization with Base Modules
Press and hold the Remote Push Button until all four LED’s light and
release the push button. The status of all 4 LED’s are shown at the
same time to indicate which LED has an assigned status based on the
following:
• Solid Red LED – no assignment
• Solid Green LED – channel is assigned and currently active
Desynchronizing a Remote from a Base Module
Press and hold the Remote Push Button for (3) consecutive flashes of all
4 LED’s and then release the push button. The status of channel
assignment is based on the following:
• Solid Green LED – Channel is assigned
• Solid Orange LED – Channel is assigned, but monitoring is
ignored
• Solid Red LED – Channel is not assigned
When entering Desynchronization mode, the #1 channel indicates its
status first. To advance to the next channel, press the push button for
one second and then release. Continue with this process to advance to
the desired channel. To change channel status (starting from a channel
that is assigned showing a green LED), press and hold the Remote Push
Button for (3) seconds and release. The status LED will change to
Orange to indicate that the channel is still assigned, but channel
monitoring is being ignored. Press and hold the Remote Push Button for
(3) seconds and release again. The status LED will change to Red to
indicate that the channel is desynchronized. When the desired status is
attained, allow the desynchronization mode to time out to accept the
change.
Desynchronization mode will time out after 20 seconds and the remote
will return to normal operation.
BASE MODULE OPERATION
Base LED Descriptions
There are several different LED’s shown on the Base Module to indicate
different signals being sent to the Remote Module.