Yokogawa DAQWORX - Manual (Page 15)

2-6 IM WX1-06E
2.4 Startng/Stoppng Data Montorng
Before carrying out the procedure below, retrieve the channel information of the target
MX100s in advance according to the instructions given in section 2.3, “Retrieving
Information about the Target MX100s/MW100s.”
Procedure
Startng Data Montorng
Click the Start Monitoring button or choose Start Montorng from the Montorng menu.
Click
Note
• If GateMX/MW is connected to the MX100, Backup mode will not be enabled when the
communication is cut while monitoring data. Even if the /DS option is enabled, the Dual
Save feature will not operate.
• If the initial communication with the target fails, retry ten seconds after the communication
failure is confirmed. Additional time is required from the start of communication until the
failure is recognized.
Dsplayng Run Status Whle Montorng Data
Click the Run tab.
You can also choose Run from the Vew menu.
Click
Monitor interval specified on the MX100
The maximum and minimum channel numbers of the channel range assigned
to the same monitor interval.
The number of channels assigned to the same monitor interval
Number registered in the MX100 unit list under System.
Computer name of the PC running the
client software that is connected
(Maximum number of connections: 16)
Assigned system number
Acquisition Status
Green: Normal (running)
Red: Error (stopped, not able to connect, or there is no
corresponding channel to monitor data.)