Yokogawa Standalone MW100 - Manual (Page 28)

28
IM CA150E
Address 0 communications need to be retransmitted over the serial port connected to the SLC504 ® . Set Protocol to DF1 Full-
Duplex and Serial Port to 2.
Click Next to accept defaults until returned to this screen and then check Continue creating more message destinations and
Next.
Now it is time to route communications to the MW100. In this case, all read and write commands issued from the SLC504 ® in
this example are sent to Node 5 (it could be set to read or write to any other address). If the SLC504 ® is going to write to devices
with different addresses, then confi ne the address to just the address of the specifi c MW100. In this example the IAP will route
any message with an address of 5 to 255 of the MW100. Click Next to continue.