Yokogawa SPS24 - Manual (Page 7)

<1. Introduction>
1-1
IM 12A01S02-01E 1st Edition : May 10, 2013-00
1. Introduction
This section outlines the SENCOM PC Software and explains general items users must
understand before using this software.
1.1 Outline
The SPS24 SENCOM PC Software has the following features.
• Handling SENCOM sensors at a laboratory and so on
• Calibrating and measuring up to four sensors simultaneously
• Managing sensor related data such as calibration and setting sensor data
• Managing up to 100 SENCOM sensors simultaneously
• Setting each password according to its control level
SENCOM sensors can perform measurement in combination with the FLXA21 2-wire analyzer.
Sensors are usually calibrated with the analyzer at the site. However, the SPS24 enables
operators to calibrate sensors at a laboratory or other places as long as the SPS24-installed PC
is provided.
SENCOM sensors are connected by using connectors, so they can be easily connected to or
detached from the cable. After calibration, the SPS24 helps sensors store the calibration data
in their own memory. When such a sensor is connected to the FLXA21, calibration data in the
sensor is automatically sent to the FLXA21.
Interface box
(up to 4 units)
SENCOM sensor
(up to 4 units)
Windows PC (user prepared) WU11 SENCOM cable USB cable
SPS24
SENCOM
PC Software
Figure 1.1 Connection example of SENCOM sensors