Yokogawa SPS24 - Manual (Page 17)

<2. Preparation and Basic Operation>
2-7
IM 12A01S02-01E 1st Edition : May 10, 2013-00
Figure 2.3 Example of RS port number view (2 sensors are connected simultaneously)
l Subsequent Launches (connections)
Connect the SENCOM sensor first and then launch SPS24. The sensor connection is
automatically detected when the program launches. The RS port number setting is retained.
To connect the SENCOM sensor after the SPS24 launch, click [Connect] in the connection
information field.
l Disconnection of SECOM Sensor (Close SPS24)
Click [Disconnect] in the connection information field. Disconnect the SENCOM sensor from the
cable if required. Close SPS24.
CAUTION
Click [Disconnect] in SPS24 first and then disconnect the SENCOM sensors from the PC.
Otherwise, the SENCOM sensors may be damaged.