Yokogawa EJA438 User Manual
Instruction manual
Table of contents
Document Outline
- Cover
- CONTENTS
- 1. INTRODUCTION
- 2. HANDLING CAUTIONS
- 2.1 Model and Specifications Check
- 2.2 Unpacking
- 2.3 Storage
- 2.4 Selecting the Installation Location
- 2.5 Pressure Connection
- 2.6 Waterproofing of Cable Conduit Connections
- 2.7 Restrictions on Use of Radio Transceiver
- 2.8 Insulation Resistance and Dielectric Strength Test
- 2.9 Installation of Explosion Protected Type
- 2.10 EMC Conformity Standards
- 3. COMPONENT NAMES
- 4. INSTALLATION
- 5. WIRING
- 6. OPERATION
- 7. BRAIN TERMINAL BT200 OPERATION
OPERATION
- 7.1 BT200 Operation Precautions
- 7.2 BT200 Operating Procedures
- 7.3 Setting Parameters Using the BT200
- 7.3.1 Parameter Summary
- 7.3.2 Parameter Usage and Selection
- 7.3.3 Setting Parameters
- (1) Tag No. Setup
- (2) Calibration Range Setup
- (3) Damping Time Constant Setup
- (4) Output Signal Low Cut Mode Setup
- (5) Integral Indicator Scale Setup
- (6) Unit Setup for Displayed Temperature
- (7) Operation Mode Setup
- (8) Output Status Display/Setup when a CPU Failure
- (9) Output Status Setup when a Hardware Error Occurs
- (10) Range Change while Applying Actual Inputs
- (11) Zero Point Adjustment
- (12) Test Output Setup
- (13) User Memo Fields
- 7.4 Displaying Data Using the BT200
- 7.5 Self-Diagnostics
- 8. MAINTENANCE
- 9. GENERAL SPECIFICATIONS
- Parts List
- INSTALLATION AND OPERATING PRECAUTIONS FOR JIS INTRINSICALLY SAFE EQUIPMENT
- INSTALLATION AND OPERATING PRECAUTIONS FOR JIS FLAMEPROOF EQUIPMENT
- REVISION RECORD