Pfister E533-MNFC - Manual (Page 3)

ENGLISH
ENGLISH
10
8
1 HOLE INSTALLATION
9 11
8 INSTALLING MOUNTING RING
From above sink, place the Mounting Ring (8A) under the Base Post Tube (8B) and
place over Sink Hole (8C). Align both to the center of sink hole.
9 BODY INSTALLATION
Feed Faucet Supply Tubes (9A), Mounting Shank (9B), and Pull-Out Hose Tube (9C)
through the hole in Mounting Ring (9D) and Sink Hole.
10 SECURING SPOUT BODY
From underneath sink, place PVC Washer (10A) over Faucet Shank (10E), Pull-Out Hose
and Supply Tubes (10C). Hand-tightening Locknut (Long) (10B). Pull the large circular
loop of Hose Guide (10D) over Pull-Out Hose and Supply Tubes (10C) Place smaller
loop of Hose Guide (10D) onto faucet shank (10E). Make sure that Faucet Body (10F)
is properly aligned to sink. Secure the faucet by tightening Locknut (Long) (10B).
11 PULL-OUT HOSE ATTACHMENT
From underneath sink, screw on Adaptor Nut (11A) to Mounting Shank (11B). Attach
Connector (11C), located on the end of the Pull-Out Hose (11D) to Mounting Shank
(Receiving Tube) (11B) by screwing it to the Adaptor Nut (11A).
3
8B
8C
8A
9A
9B
9D
9C
10A
10F
10C
10B
10D
10G
10E
11A
11A
11B
11B
11C
11C
11D
11D