beautypg.com

English – Pfister 8T8-CT1C User Manual

Page 4

background image

ENGLISH

4

4

3

2

1

B

2

10

6

8

7

9

5

C

English: Thank you for purchasing this Price Pfister

product. All Price Pfister products are carefully engineered,

and factory tested to provide long trouble-free use under

normal conditions. This product is easy to install using

basic tools and our easy to follow illustrated instructions.

If you have any questions regarding this product, see info

on previous page.
1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before

proceeding. Price Pfister recommends calling a professional

if you are uncertain about installing this product!
This product should be installed in accordance with all local

and state plumbing and building codes.
2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply

valves. These are usually found under the sink or near the

water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the mounting surface

thoroughly.
3 ASSEMBLY INSTRUCTIONS

If operating pressures exceed 5 BAR (~75 PSI), the use

of a pressure reducer is recommended. Before proceeding

with the assembling, we advise to clean the hot and cold

water tubes, in order to avoid build-up of dirt that could

compromise the functioning of the valve.

4 VALVE INSTALLATION (Fig.A)

For Center Hole (1) on plaster wall, use the edges from

Plaster Guard (2) to inscribe Cutting Edges (3). Cut Center

Hole (1) along inscribed lines, as shown. The Depth is

measured from center of Valve Body (2) to finished wall

surface (1) is 1 3/8" min. to 1 31/32" max. The tub spout and

shower outlet holes on the wall are to be 1 1/4" diameter.
5 VALVE INSTALLATION (Fig.B&C)

Take out Plastic Caps (1) with the help of a flat screwdriver.

Plug bottom valve outlet with Pipe Plug (2). Place the

Valve Body (3) in the wall with the Shower Water Outlet

(4) towards the top as shown. Valve Body inlets (5&6) and

outlets (7&8) are designed to accommodate 1/2-14 NPT

pipe. Connect the Hot Water Supply (9) to the Left Inlet and

the Cold Water Supply (10) to the Right Inlet.
WARNING: When attaching threaded fittings, use thread

sealant or PTFE Plumber’s tape according to manufacturer’s

instructions.
CAUTION: When using iron pipes, it is not recommended

to reduce outlet pipe diameter.
CAUTION: For Copper Sweat joints, it is important

to remove Valve Cartridge and other Plastic Components

from the Valve Body before soldering. Use copper pipe

adapters (not furnished) in this type of installation.

Supply

Suggested

Maximum

Minimum

Hot Water

Temperature

65 Cº (150ºF)

80 Cº (175ºF)

15 Cº (60ºF)

Operating

Pressure

3 BAR (44PSI)

5 BAR (73PSI)

0.5 BAR (7PSI)

1 1/4” DIA. Hole

1 1/4” DIA. Hole

1 3/8” Min - 1 31/32” Max

A

1

2

3