Watlow WATVIEW - Manual (Page 31)

■
3 1
■
Wa t V i e w
Controller-Specific Features
Unique controller features are supported by special programs or
tools that can be selected from the Tools menu. This section describes
those tools. The online help is automatically reconfigured as you add
or remove controllers. Be sure to check the help contents after you
install a controller for relevant controller and tool specific topics that
may appear.
Series F4 Controllers
These tools are available when Series F4 controllers are installed.
Some are only available with ramping controllers (F4S and F4D).
Help Topics: Using the Series F4 S/D with WatView
What is a Profile Image?
What is a Profile?
How does the Controller Setup Affect My Profiles?
Create a New Profile Image
Send a Profile Image to a Controller
Start a Profile
F4 Save Changes to EE Tool
Use this feature to save the current parameter settings in the
Series F4 controller’s nonvolatile memory. This is important to do
after setting up the controller using WatView, because the parame-
ters are not automatically saved when you set them through the
serial interface. The settings are stored automatically only when you
set them using the controller’s onboard keypad and display.
F4S and F4D Profile Editor
The F4 Profile Editor tool allows you to read profiles from any
Series F4 and save them on a computer hard drive or floppy disk.
You can edit those profiles and load them to any Series F4 on the
network that is similarly configured. The Profile Editor also allows
you to convert profiles that were set up on one Series F4 for use with
a Series F4 set up differently.