Watlow Series 734 Data Communications - Manual (Page 8)

How to Use Data Communications
8
WATLOW Series 733/734
Prompt This Range Factory Appears…
Value Default
[bAUd] [bAUd] [bAUd] [bAUd] [bAUd] (Baud rate)
300, 600, 1200, 2400, 4800, 9600
1200 if comms unit
[dAtA] [dAtA] [dAtA] [dAtA] [dAtA] 7o = 7 data bits and odd parity
7E = 7 data bits and even parity
8n = 8 data bits and no parity
7o if comms unit
(Start bit = 1) (Fixed)
(Stop bit = 1) (Fixed)
[Prot] [Prot] [Prot] [Prot] [Prot] FULL = ANSI X3.28 2.2 - A.3 FULL if comms unit
On = XON - XOFF
[Addr] [Addr] [Addr] [Addr] [Addr] 0 to 31 (ASCII) 0 if Prot = FULL
Program Mode - Communications Prompts
Enter the Program Mode at the front panel:
[0)º0]
Press key sequence:
The display shows:
[C_F`]
Continue pressing:
Until:
[bAUd]
Current value displays alternately:
[1200]
or
[bAUd]
Press to change value: or
Press for next prompt:
Press to exit:
Document any changes.
Enter data on a photocopy of this page.
Comms Setup
Table 1 -
Program Mode
prompts and De-
scriptions.