Proface APL3000B - Node Box PC User Manual
Page 38
Chapter 2 Specifications
2-11
Switches
The following switch settings corresponding to each Serial Interface need to be signified. To set the switches
which are on the PS-A’s circuit board, remove the PS-A’s Rear Cover. Please refer to "3.2.1 Removal/
Attachment the Rear Cover" (page 3-6). The switches are located as follows;
Switch
Location
Switch Name
Compatible
I/F
Factory
Settings
Description
A
Serial Mode Select SW
COM3
All OFF
(RS-232C)
10-point dip switch. Designates COM3
communication settings. For Serial Mode
Select SW details, see Table (2).
B
System Set SW
-
See
Table (1)
10-point dip switch. For System Set SW and
the factory settings details, see Table (1).
C
RI/+5V Changeover SW
COM1
RI
Changes # 9 pin (RI <---> +5V).
D
RI/+5V Changeover SW
COM2
RI
Changes # 9 pin (RI <---> +5V).
E
Touch Panel's Communication
Changeover SW
COM4
USB
USB
Changes the Touch Panel communication
method. (Serial <---> USB)
(If “Serial” is selected, COM4 cannot be used.)
ON
12345678910
10
ON
123456789
RI
A
B
C
D
E
5V
RI
5V
USB
RS232C
Inside of the rear