Proface APL3000B - Node Box PC - Manual (Page 22)

22
Connecting USB Cable Clamp
„ Attaching the USB Cable Clamp
(1) Place the PL unit face-down on a flat sur-
face as shown below. Your PL unit has
four USB connectors.
• When using two or more USB ports, be
sure to first connect one USB cable to the
lower USB connector, and then connect the
second USB cable to the upper USB con-
nector.
• When using only one of the USB ports, be
sure to use the lower USB connector. This
allows you to securely clamp the USB
cable in the cable clamp.
(2) Fix the USB holder with two screws.
The torque required to tighten these
screws is 0.5 to 0.6 N•m.
(3) As the figure shows, pass the USB Cable
Clamp’s band around the depressed sur-
face of the holder, twist the USB Cable
Clamp’s band around the USB cable, pull
the band in the direction of the arrow, and
then fasten the band using the clamp.
• Be sure the clamp is securely holding the
USB cable’s plug and collar.
• Be sure the clamp is positioned as shown
in the following image, with the clamp
pointing upwards - not to the side. This is
to keep the clamp from interfering with
nearby connectors and their cables.
„ Removing the USB Cable Clamp
(1) To remove the clamp from the USB
cables, push down on the clamp strap’s
clip to release it while pulling up on the
clamp.
Installation prerequisites for
standards
The following units are UL/c-UL recognized
products:
(UL File No.E171486)
„
Built-in battery unit version
1
2 4
3
USB
LAN1 LAN2
1
2 4
3
USB
LAN1 LAN2
SPK DV1-I
RESET
Lower USB
Interface
Upper USB
Interface
Product
Model No.
UL/c-UL Registration Model
No.
APL3000-BA 3582302-02
APL3600-TA
3582302-02
Front Module: 3620003-01
APL3700-TA
3582302-02
Front Module: 3620003-02
APL3900-TA
3582302-02
Front Module: 3620003-03
APL3600-KA
3582302-02
Front Module: 3620003-04
APL3700-KA
3582302-02
Front Module: 3620003-05