Proface APL3000B - Node Box PC - Manual (Page 17)

17
unit without adjusting the Panel Cut size.
As shown in the following diagram, simply
remove 7 screws from the upper and lower
positions to remove attachments from the
PL-3600K series unit.
Panel Cut size without attachment
(2) Confirm that the installation gasket is
attached to the PL unit and then place the
PL unit into the panel from the front.
• It is strongly recommended that you
use the installation gasket, since it
absorbs vibration in addition to repel-
ling water.
For the procedure for attaching the
installation gasket, refer to “PL3000
Series Hardware Manual”.
(3) Insert each fastener’s hook into the slot
and tighten it with a screwdriver. Tighten
the screws gradually in an even, criss-
cross pattern.
The number of the slots varies depending
on the model.
PL-3600T Series : 4 slots
PL-3600K/3700T Series: 8 slots
PL-3700K/3900T Series: 12 slots
PL X Y
Panel
thickness
PL-3600K Series
(3612KPM/
4612KPM
compatible)
383.54
[15.10] 275.59
[10.85]
1.6[0.06]
to
10.0[0.39]
Attachments
Insertion Slots
Locations of the 4 slots
Insertion
Slots
Locations of the 8 slots
Insertion
Slots
Locations of the 12 slots