Ramsey Winch HDG-350 (JERR-DAN) - Manual (Page 8)

6
2. Remove clutch housing (item #9) and clutch
(item #5) from winch assembly.
Remove two keys (item #31) from keyways. A
screwdriver can be used, at notch, to aid in the
removal of keys. Once keys have been re-
moved, drum (item #7) and thrust washer
(item #46) can be removed from drum shaft.
3. Remove motor and coupling (item
#27) from (item #3) adapter by
unscrewing two (item #23) cap-
screws with lockwasher.
Remove keys (item #11) from
worm shaft. Unscrew four cap-
screws (item #22) and remove
adapter from gear housing. Re-
place adapter seal (item #41) and
gasket (item #29).
4. See page 12 for servicing
the oil cooled brake. Re-
move brake housing mount-
ing screws (item #19) and
remove brake with gasket.
Replace gasket (item #29).
Remove worm (item #13)
and bearings (item #14)
from gear housing. Use soft
hammer to gently tap input
end of worm and drive worm and bearing from gear housing. Once worm
has been removed from housing, bearing can be pressed from end of
worm.
Check for signs of wear or damage to worm (item #13) and bearing (item
#14). Replace if necessary.