Ramsey Winch HDG-350 (JERR-DAN) User Manual

Page 11

13. Press bearing (item #14) onto

worm and into housing. NOTE:
Be sure that thick shoulder of

bearings outer race (side with
manufacturer's name and part
number) is out, away from worm
threads.

Place gasket (item #29) onto

adapter (item #3). Attach adapter
to gear housing using four (4)
capscrews (item #22). TIGHTEN
CAPSCREWS TO 12 ft-lbs. (16.3

Nm) EACH. Insert keys (item #11) into keyways of worm shaft. Slide
tapered end of coupling (item #27) over end of worm shaft. Be sure roll
pin (item #38) is in coupling.

Place motor shaft, with key in keyway, into coupling. Secure motor to
adapter, using two (2) capscrews (item #23) and lockwashers. TIGHTEN
CAPSCREWS TO 75 ft-lbs. (102 Nm.) EACH.

14. Place winch with gear housing cover

down on work bench. Drum shaft

should be in vertical position. Slide
thrust washer (item #45) over drum
shaft and slide downward until washer
rests on gear housing. Set springs

(item #43) into pockets of gear hous-
ing with drag brakes (item #28) on top
of springs. Slide drum assembly (item
#7) onto drum shaft with drum jaws
upward.