Ramsey Winch HDG-350 (JERR-DAN) User Manual

Page 12

15. Place thrust washer (item #46) over

end of drum shaft and slide downward

until spacer rests on drum. Press
drum downward to compress springs
in gear housing.

Insert keys (item #31) into keyways
with sharp edge of keys pointing out-

ward and notched end of keys up-
ward. A rubber or brass mallet will be
needed to gently tap keys into posi-
tion.

Apply grease to keys and end of shaft. Place jaw clutch (item #5) over
end of shaft and slide jaw clutch over keys.

Set clutch housing (item #9) over end of drum shaft. Pull jaw clutch (item
#5) upward, toward clutch housing, enough to allow yoke, in clutch
housing, to fit properly in groove around jaw clutch.

16. Attach frame assembly (item #1) using six capscrews (item #21) with

lockwashers and two capscrews (item #20) with lockwasher. Torque
capscrews to 34 ft-lbs. (46 Nm.) each. Insert plug (item #36) into bot-
tom of gear housing. Permatex may be applied to threads to help prevent
leakage.

Attach adapter rod (item #26) to clutch shaft using pin (item #37).

Pour 1 pint of SAE 140 EP gear oil into housing through hole in top of
housing. Insert relief fitting

(item #34) into reducer
(item #35). Reducer should
then be placed into hole on
top of gear housing. Tighten
fitting and reducer securely.