Ramsey Winch H-930r DOW-LOK w/Air Shifter for Grant Wrecker User Manual

Page 9

INSTRUCTIONS FOR OVERHAUL

Refer to parts lists and parts drawing
for corresponding part numbers.

1. Shift clutch into engaged “IN”

position. Drain oil from gear hous-
ing by removing plug (item #78)
from end bearing.

Remove frame angles (item #3 &
#4) from winch by removing cap-
screws (item #48 & #49) with
lockwashers (item #65)

2. If the air cylinder and shifter needs to be

removed, remove (4) capscrews (item
#40) that hold shifter cover (item #37)
and shifter bracket (item #34) onto clutch
housing (item #17). Remove cotter pin
(item #66) and clevis pin (item #67) that
hold clevis (item #27) to yoke (item
#30). Loosen jam nuts (item #58) and
unscrew stud (item #90) from clevis and
air cylinder (item #68).

To remove air cylinder from shifter brack-
et, remove (4) capscrews (item #56) and
lockwashers (item #60).

Remove clutch housing from end of drum
shaft along with yoke (item #30).

NOTE: It will be necessary to pull the yoke upward inside the clutch housing as far as it will go in order to clear
the locking ring attached to the drum. Press in on retainer plate (item #83) to relieve spring tension and remove
the retainer ring (item #28).