Ramsey Winch H-930r DOW-LOK w/Air Shifter for Grant Wrecker User Manual

Page 13

13. Apply grease to end of shaft, opposite gear. Apply

grease to bushing in gear housing (item #18).
Place greased end of shaft through bushing in gear
housing. Place gasket (item #71) onto gear hous-
ing cover (item #12). Apply grease to gear end of
shaft and cover bushing. Place cover onto shaft
and secure to housing with (8) capscrews (item
#42). Tighten capscrews to 39 ft-lbs. (52 Nm)
each.

14. Press bearing (item #33) onto worm (item #29).

NOTE: Be sure that thick shoulder of bearing’s
outer race (side with manufacturer’s name and
part number) is out, away from worm threads.
Press bearing and worm into gear housing.

Slip gasket (item #69) onto brake housing (item
#16). Use (6) capscrews (item #51) to secure
brake housing to gear housing. Tighten cap-
screws to 45 ft-lbs. (61 Nm) each.

Place key (item #21) into keyway of worm (item
#28). Refer to Reassembling and Checking the
Brake, page 6 .

15. Press bearing (item #33) onto worm and into

housing. NOTE: Be sure that thick shoulder of
bearing’s outer race (side with manufacturer’s
name and part number) is out, away from worm
threads. Attach adapter (item #2) to gear hous-
ing using (6) capscrews (item #53). Tighten
capscrews to 45 ft-lbs. (61 Nm) each.

Insert key (item #22) into keyway of worm
shaft. Slide coupling (item #9) over end of
worm shaft. Attach adapter plate (item #24) to
adapter using (8) capscrews (item #50).
Tighten capscrews to 21 ft-lbs (28 Nm) each.

Place motor shaft, with key in keyway, into cou-
pling. Secure motor to adapter, using (2) cap-
screws (item #54). Tighten capscrews to 102
ft-lbs. (138 Nm) each.