Ramsey Winch H-930r DOW-LOK w/Air Shifter for Grant Wrecker User Manual

Page 10

3. Slide the locking ring (item #10) from the clutch. NOTE: The locking

ring cannot be removed unless the clutch is engaged, with dowel
pins (item #80) seated in the shaft keyways.

Rotate the drum so the (8) balls (item #32) and (4) dowel pins
(item #80) can be removed.

If necessary, the clutch (item #8) may be disassembled from the
drum by removing the (8) capscrews (item #44). Slide drum (item
#1) from drum shaft.

4. Remove motor (item #75) from adapter

plate (item #24) by removing capscrews
(item #54). Remove adapter plate and
coupling (item #9) from adapter (item
#2) by removing (8) capscrews (item
#50).

Remove the key (item #22) from worm
shaft. Unscrew (6) capscrews (item #53)
and remove adapter from gear housing.
Replace adapter seal (item #84) and gas-
ket (item #69).

The drag brake disc (item #14), spacer
(item #93), and spring (item #82) should
be examined and replaced if necessary.

5. For further instructions, refer to Servicing the Oil Cooled

Safety Brake on page 4. Remove brake housing (item
#16) from gear housing by removing (6) capscrews
(item #51). Remove key (item #21) from worm.
Remove worm (item #29) and bearings (item #33)
from gear housing. Use a soft hammer to gently tap
input end of worm and drive worm and bearing from
gear housing. Once worm has been removed from gear
housing, bearing can be pressed from end of worm.

Check for signs of wear or damage to worm and bear-
ings. Replace if necessary.