Ramsey Winch H-930r DOW-LOK w/Air Shifter for Grant Wrecker User Manual

Page 11

6. Remove gear housing cover (item #12) from gear hous-

ing (item #18) by removing (8) capscrews (item #42).
Thread (2) of the capscrews into the two tapped holes of
cover and tighten until the cover comes loose from the
gear housing.

Remove the cover gasket (item #71) and pull shaft (item
#26), with gear attached, from gear housing.

7. Check for signs of wear on gear teeth. If necessary, replace gear by

removing (10) capscrews (item #46) and washers (item #64).

Place new gear (item #15) onto gear hub. Align holes in gear with holes in
hub. Press gear into hub. Be sure gear is seated all the way on the hub.
Use (10) capscrews (#46) and lockwashers (item #64) to secure gear to
hub. Tighten to 121 ft-lbs (164 Nm) torque each.

8. If shaft and/or hub is damaged, replace as follows:

a. Tap keys (item #23) into short keyways of drum shaft

(item #26).

b. Press shaft (item #26) and keys through gear hub (item

#20) until end of keys on long end of shaft are flush with
hub.

c. Secure gear to hub using (10) capscrews (item #46)

with lockwashers (item #64). Tighten to 121 ft-lbs. (164
Nm) torque each.