Ramsey Winch H-800 (JERR-DAN) - Manual (Page 15)

19. Attach frame and spacers (item #59) to
winch assembly. Use capscrews (items #34
and #33) and lockwashers (item #38).
Tighten to 290 ft-lbs. (393 Nm) each. Insert
plug (item #46) into hole in bottom of gear
housing. Remove plugs (items #41 and
#45) from top of housing. Pour 3 3/4 pints of
E.P. 140 oil into hole and replace plugs.
Check the action of the clutch by shifting and
freespooling the winch drum several times.
The shift pattern plate on top of the clutch
housing is adjusted at the factory to provide
reliable shifting of the Dow-lok
® clutch. If the
plate should loosen or be removed, you must
readjust the plate. Shift the handle to disen-
gage the clutch and hold against the internal
stop. With the latching pin in the “OUT” slots,
push the shift pattern plate toward the cable
drum. Unsnap the plastic lever cover from the
pattern plate. Tighten the four capscrews
which hold the plate to the housing. Snap
lever cover back into place around the pattern
plate.
15