Ramsey Winch H-800 (JERR-DAN) - Manual (Page 10)

4. Remove bearing cap (item #6) and gasket
(item #39) by unscrewing six capscrews
(item #28) and lockwashers (item #36).
Drag brake disc (item #10) spacer (item
#57), and spring (item #53) should be
examined and replaced if necessary.
5. Remove motor (item #58) from adapter (item
#2) by removing two capscrews and lock-
washers. Remove adapter (item #2) from
gear housing by removing six capscrews.
Replace pilot seal (item #51) and gasket
(item #39). Remove thrust bearing (item
#22) and thrust washers (item #56).
Remove worm (item #19) and bearing (item
#21) from gear housing. Use a soft hammer
to gently tap input end of worm and drive
worm and bearing from gear housing. Once
worm has been removed from housing bear-
ing can be pressed from end of worm.
Check for signs of wear or damage to worm
(item #19) and bearing (item #21). Replace
if necessary.
6. Remove gear housing cover (item #9) from
gear housing (item #14) by unscrewing eight
capscrews (item #27). Thread two of the
capscrews into the two tapped holes of cover
and tighten. This will pull the cover loose from
the gear housing.
Remove cover gasket (item #40) and pull
shaft (item #17), with gear (item #12) and
spacer (item #55) attached, from gear hous-
ing.
10