Ramsey Winch H-800 (JERR-DAN) - Manual (Page 11)

7. Check for signs of wear on gear teeth. If nec-
essary, replace gear (item #12). If gear hub
is damaged, replace gear.
Check lube fittings (item #43) for damage
and replace if necessary. Remove lube fittings
(item #43) and reducers (item #45) from
ends of shaft, if following step 8 below, and
reinstall after step 8.
8. If shaft is damaged, replace as follows:
a. Tap keys (item #16) into short keyways
of drum shaft (item #17).
b. Press shaft (item #17) and keys (item
#16) through gear hub until end of keys
on long end of shaft are flush with hub.
9. Check gear housing bushing (item #4) and
o-ring (item #44) for signs of wear. Replace
if necessary by pressing old bushing from
gear housing (item #14). Press new bushing
into place and insert new o-ring (item #44)
into groove inside of bushing.
11