Ramsey Winch RPH-15000T - Manual (Page 3)

OM-914020-0199-A
1
wire rope and a 24.9 Cu. In./Rev. motor.
*These specifications are based on recommended 13 mm
*Rated line pull
Cable capacity
Line speed
(at 15 GPM)
per layer
35
7,6
25
10
FPM
MPM
Ft.
M.
29
8,8
75
22
34 39
10,3 11,8
38
125
53
177
57.0
Lbs.
Kn.
48.4 42.0 37.0
Gear Reduction....................................................................................7.7:1
Weight (without cable)....................................................300 lbs. (136 kgs.)
(Kn).............................................................................................. 57
LAYER OF CABLE 1 2 3 4
10,880 12,810 9,460 8,365
Rated Line Pull (lbs.).........................................................................15,000
NOISE LEVEL: 74 dB(A)
RAMSEY HYDRAULIC PLANETARY WINCH MODEL RPH-15,000T
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and safety
procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until you have
carefully read and understand the "WARNING" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch we
make. If the need should arise, warranty procedure is outlined on the back of your self-addressed postage paid
warranty card. Please read and fill out the enclosed warranty card and send it to Ramsey Winch Company. If you
have any problems with our winch, please follow instructions for prompt service on all warranty claims. Refer to
back page for limited warranty.
SPECIFICATIONS*
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.
WARNINGS:
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
DO NOT LEAVE CLUTCH ENGAGED WHEN WINCH IS NOT IN USE.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PERSONNEL.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
CABLE CLAMP (SETSCREW) IS NOT DESIGNED TO HOLD LOAD.
IN CAR CARRIER APPLICATIONS, AFTER PULLING VEHICLE ON CARRIER, BE SURE TO SECURE
VEHICLE TO CARRIER BED. DO NOT MAINTAIN LOAD ON WINCH CABLE WHILE TRANSPORTING
VEHICLE. DO NOT USE WINCH AS A TIE DOWN.
WHEN PULLING A HEAVY LOAD PLACE A BLANKET, JACKET, OR TARPAULIN OVER THE CABLE FIVE
OR SIX FEET FROM THE HOOK.
AVOID CONDITIONS WHERE LOAD SHIFTS OR JERKS OCCUR, AS THEY MAY INDICATE A DANGEROUS
SITUATION.