Ramsey Winch RPH-15000T - Manual (Page 13)

OM-914020-0199-A
11
With pin (item #26) installed in coupling, align keyway of coupling (item #3) with key and end of input shaft below.
Slide coupling over end of shaft (item #8). Place gasket (Item #23) into position on motor mounting surface of end
bearing (item #6). Insert brake shaft (with key) into coupling. Use (2) screws (item #16) to attach brake
cover/shaft assembly to motor end bearing. Torque capscrews to 85 ft lbs each. Re-attach brake module
assembly to brake cover/shaft assembly using brake module assembly screws. Torque capscrews to 85 ft. lbs.
each.
NOTE: Care must be taken to assure cover and brake module are seated properly prior to installing 1/2-13UNC
assembly bolts. Damage will occur to rotor stack or shaft snap ring if not properly seated.