Ramsey Winch H-49,8 - Manual (Page 13)

FIGURE 13
Press bearing #40 onto worm #35. NOTE: Be sure
that thick shoulder of bearings outer race (side with
manufacturer's name and part number) is out, away
from worm threads. Press bearing and worm into
gear housing. Slip gasket #62 onto bearing cap #18.
Use six capscrews #52 to secure bearing cap to
gear housing. Tighten capscrews to 16.1 Nm (12 ft
lb) each. Place key #25 into keyway of worm #35.
FIGURE 14
Attach adapter #2 to gear housing using six
capscrews #51. Tighten capscrews to 16.1 Nm
(12 ft lb) each. Insert key #25 into keyway of worm
shaft. Slide tapered end of coupling #1 over end of
worm shaft.
Place motor shaft, with key in keyway, into coupling.
Secure motor #67 to adapter, using two capscrews
#52. Tighten capscrews to 53 Nm (39 ft lb) each.
FIGURE 15
Place winch with gear housing cover down on work
bench. Drum shaft should be in vertical position.
Set springs #75 & #76 into pockets of gear housing
with drag brakes #12 on top of disc #77and springs.
Apply grease to shaft and drum bushings. Slide
drum assembly #13 onto drum shaft with drum jaws
upward as shown.
13
FIGURE 13
FIGURE 14
FIGURE 15