Ramsey Winch H-49,8 - Manual (Page 10)

FIGURE 4
Remove bearing cap #18 from gear housing by
unscrewing six capscrews #52.
Remove worm #35 and bearings #40 from gear
housing. Use a soft hammer to gently tap input end
of worm and drive worm and bearing from gear
housing. Once worm has been removed from
housing, bearing can be pressed from end of worm.
Check for signs of wear or damage to worm #35 and
bearing #40. Replace if necessary.
FIGURE 5
Remove gear housing cover #10 from gear housing
#20 by unscrewing capscrews #46 & 45. Thread
two of the capscrews into the tapped holes of th
cover and tighten. This will pull the cover loose from
the gear housing.
Remove cover gasket #64 and pull shaft #29, with
gear attached, from gear housing.
FIGURE 6
Check for signs of wear on gear teeth. If necessary,
replace gear by removing six capscrews #47.
Place new gear #16 onto gear hub #14. Align holes
in gear with holes in hub. Press gear onto hub.
Be sure gear is seated all the way on the hub.
Use six capscrews #47 and lockwashers #59 to
secure gear to hub. Torque to 61 Nm (45 ft lb) each.
10
FIGURE 4
FIGURE 5
FIGURE 6