Ramsey Winch CHEVY WRAPAROUND KIT 295925 - Manual (Page 5)

KI-913356-0301-C 4
Step 9
Repeat Steps 5-8 above for right hand side. DO NOT TIGHTEN HARDWARE COMPLETELY.
Step 10
Note: You will need assistance for this step.
Remove the (3) 3/8-16NC x 1-1/4” capscrews #16 from L.H. side of center unit where the side plate
attaches to the upper support bracket and the channel (Figure 8).
Have someone position wrap shim #31 between the side plate and left wraparound #4 (Figure 9).
Align the (2) 1/4-20NC x 1-1/4 capscrews #14 holding the headlight grille to the wraparound with the
appropriate holes in the side plate and slide into place (Figure 9). Secure using (2) 1/4” nuts #19.
Step 11
Re-insert (2) 3/8-16NC x 1-1/4 capscrews #16
through light tube, shim, side plate, and channel and
(1) 3/8-16NC x 1-1/4 capscrew #16 through light
tube, shim, side plate, and upper support bracket
and secure each with nut #21 (Figure 10).
Tighten all hardware to proper torque. (See torque
value chart, page 8).
Figure 8
Figure 9
Figure 10