Ramsey Winch CHEVY WRAPAROUND KIT 295925 - Manual (Page 3)

KI-913356-0301-C 2
Step 4
It will be necessary to remove vehicle grille to install upper mounting brackets. To remove grille,
open hood and first remove plastic panel on top of grille. Use a door panel removal tool or a flat
screwdriver to remove center pins of plastic rivets that hold panel in place and lift away panel. The
grille can then be easily removed by using a Phillips screwdriver to release (4) plastic grille fasteners
and a 10mm socket wrench to remove center bolt near the hood latch (Figure 3). The outer ends of
grille are snapped in place with metal clips and can be removed by carefully pulling grille until snaps
release.
Step 5
Note: It is not necessary to remove the vehicle bumper to install this kit. Install L.H. upper mounting
bracket #10 (Figure 4) on existing bumper mounting bolt. Bracket must be positioned from the top
with the two slotted holes pointing toward the center of the vehicle. Secure using 1/2” lockwasher #26
and 12 mm nut #22. Tighten using a crow’s foot attachment and ratchet (Figure 4).
DO NOT TIGHTEN
HARDWARE COMPLETELY.
Install (1) 3/8-16NC X 1” capscrew #15 through 3/8” flatwasher #25, for each of the holes in top of
upper support bracket #12 (Figure 4). Secure using 3/8” flatwasher #25 and 3/8” nut #20.
DO NOT
TIGHTEN HARDWARE COMPLETELY. Reattach the grille and top panel (refer to Step 4 above) before
continuing the installation.
Figure 3
Figure 4