Ramsey Winch CHEVY WRAPAROUND KIT 295925 - Manual (Page 4)

KI-913356-0301-C 3
Figure 5
Step 6
Note: You will need assistance for this step.
Have someone hold the center unit while you insert the
winch mounting channel #2 between side plates of center
unit #5. Channel shims #29 are inserted between the end of
the channel and the side plate of the center unit on both
sides. Secure each side of channel using (2) 3/8-16NC x 1-
1/4 capscrews #16 with nuts #20 (Figure 5). Note: Do not
tighten hardware at this location, as you will need to remove
these nuts to install the wraparound in a later step.
Step 7
Mount center unit on vehicle and secure each side at the lower support bracket using (3) 1/2” X 1-1/4”
capscrews #17 with (3) 1/2” nuts #21 (Figure 6). Attach each side of center unit to upper support
bracket using (1) 3/8-16NC x 1-1/4 capscrew #16 with nut #20.
DO NOT TIGHTEN HARDWARE.
Step 8
Remove the two nuts #19 securing the headlight grille #28 to
the L.H. wraparound #4. It is not necessary to remove the
capscrews #14 or flat washers #23 (Figure 7).
Figure 6
Figure 7