Ramsey Winch RPH-20000 (RAMSEY GBX) User Manual

Page 14

12.With pin (item #44) installed in coupling, align keyway of coupling (item #6) with key and end of

input shaft below. Slide coupling over end of shaft (item #11). Place gasket (Item #34) into posi-
tion on motor mounting surface of end bearing (item #8). Insert brake shaft (with key) into cou-
pling. Use (2) capscrews (item #21) to attach brake assembly to motor end bearing.

Alternately tighten one, then the other of the capscrews (item #21) in a back and forth manner,
thus compressing spring (item #45) and pulling the brake assembly down against end bearing
(item #8). Torque capscrews to 85 ft lbs each.

NOTE: Care must be taken to assure brake assembly is seated properly prior to installing 1/2-
13UNC assembly bolts. Damage will occur to rotor stack or shaft snap ring if not properly seated.

13.Attach motor (item #37) with gasket (item #33) to brake (item #31). Use (2) capscrews (item #20)

and torque to 74 ft. lbs. each. Securely connect tube (item #46) to elbow (item #29), in bottom of
valve (item #47) and in brake (item #31).