Ramsey Winch RPH-20000 (RAMSEY GBX) - Manual (Page 10)

5. Pull drum assembly (item #1) upward from end bearing (item #9). Remove quad-rings (item #38
& #39) from grooves in drum bushings. Remove input shaft (item #11), clutch spring (item #45)
and washer (item #27) from end bearing (item #9). Examine key (item #10) and input shaft for
signs of wear, replace if damaged.
Examine drum assembly (item #1) for signs of wear. If splines inside of drum driver (332166) are
damaged, drum driver must be replaced. Remove drum driver by unscrewing (8) capscrews
(414962). Place well-oiled o-ring (462053) into drum driver groove and attach driver to drum
(332165) using (8) capscrews (414962). Torque capscrews to 55 ft. lbs. each, in criss-cross pat-
tern.
Press old bushings from drum and drum driver. Remove o-rings (462055 & 462052) from
grooves in drum and drum driver bushing (412092). Place well-oiled o-rings (462055 & 462052)
into grooves in drum and outer diameter of drum driver bushing (412092). Press new bushing
(412091) into end of drum opposite drum driver and press bushing (412092) into drum driver until
flange of bushings are flush against drum and driver. Secure bushings to drum and drum driver
using (2) capscrews (414819).
7