Ramsey Winch RPH-20000 (RAMSEY GBX) - Manual (Page 11)

6. Remove output coupling (item #5) and coupling shaft (item #7) from end bearing (item #9).
Examine bearings (item #13), pressed in output coupling (item #5), for signs of wear. Replace
bearings, if necessary, by pressing old bearings from coupling and press new bearings (item #13)
into each end of output coupling (item #5). Place coupling shaft (item #7) into bearings (item
#13).
7. Remove (8) capscrews (item #15) to pull gear housing cover from ring gear. Remove input
thrust washer, sun gear and carrier assemblies from inside of ring gear. Remove ring gear from
end bearing (item #9) by removing (10) capscrews (item #16) from back side of end bearing.
Examine shifter shaft (item #12) for signs of wear, replace if necessary. Examine bushing (item
#14) for signs of wear. Replace bushing, if necessary, by pressing old bushing from housing and
pressing new bushing into place.
8