Ramsey Winch Powermaster Series 20K Bumper and Winch - Manual (Page 15)

13 OM-914206-1208-B
7. Remove drum #13 from motor end bearing #3. Remove drum seal #55. Check for signs of
wear and replace if necessary.
8. Remove input shaft #14 from motor end bearing #3.
9. To remove motor #37 from motor end bearing #3, first detach hydraulic brake release hose
assembly #64 from elbow fitting #33 and #34. Loosen (2) ½-13 capscrews #24. Remove motor
gasket #35, and (11) brake springs #59.
10. To remove motor control valve #60, loosen (3) 3/8-16 NC capscrews #28. Lift motor control
valve #60 from motor #37.
Note: Do not run winch with hydraulic brake release hose assembly disconnected.
3
13
55
3
14
3
33
64
28
60
35 59
64 34
TO ITEM 33
TO ITEM 34
37
24