Ramsey Winch Powermaster Series 20K Bumper and Winch - Manual (Page 12)

10 OM-914206-1208-B
4. Slide clutch end bearing #2 from drum. Drum freespool drag puck #12, drum freespool spring
# 58, and brake disc spacer # 62 will fall out when end bearing is removed from drum. Retain
these items for re-assembly.
To remove shifter yoke #19, drive spring pin #50 inward through shifter yoke. Lift shifter
assembly out by pulling up on shifter handle assembly #17 until shifter shaft #15 is clear of
shifter yoke #19. Yoke can then be lifted out of end bearing.
To replace handle #17 on shifter shaft #15, first remove spring pin #51, then slide handle
assembly #17 from shifter shaft #15. O-ring #45 can be replaced at this time.
To replace shifter detent bracket #20, first remove (2) ¼ x 20 capscrews #23 and (2) ¼
lockwashers # 31, then remove shifter detent bracket #20 and replace.
12
58
20 31
46
23
62
30
26
65
19
50
2
15
51
45
17