Ramsey Winch 50K WILDCAT WINCH - Manual (Page 17)

16 OM-914225-0209-B
ASSEMBLY OF OUTPUT CARRIER
Note: Item Numbers refer to Carrier parts list on page 15
1. Install the output shaft # 308 into the carrier and install snap ring #309 on the output shaft.
2. Place output carrier #301 on flat clean surface.
3. Press one set of needle bearings #306 into gear #302. Turn gear #302 over.
4. Install spacer #307, and the next needle bearing #306.
5. Slide the gear #302 into position in the output carrier #301.
6. Place thrust washer #303 on top of gear #302. Insert carrier pin #304 into carrier #301
7. Turn output carrier #301 on its side so that the gear #302 is on top.
8. Insert a thrust washer between gear #302 and output carrier #301. Completely insert carrier
pin #304 into carrier #301 using care to align the roll pin hole in carrier pin #304 with the roll
pin hole in the output carrier #301.
9. Drive roll pin #305 into output carrier #301 until roll pin #305 is flush with surface of the output
carrier #301.
10. Repeat steps 2-9 to install the two remaining gears into the output carrier.