Ramsey Winch 50K WILDCAT WINCH - Manual (Page 13)

12 OM-914225-0209-B
18. While continuing to support the drum #14, remove the clutch #9, snap ring #60 and spacer
#27.
19. The output carrier assembly #2 may be slid from the drum assembly.
20. The drum #14 is now supported only by the nylon strap and may be removed.
21. The (2) bushings #34 may be pressed from the drum if replacement is necessary.
22. To remove gear end bearing #19, from mounting angles #6 and #7, first remove (4) 7/8-9NC
bolts #67 and (4) nuts #68 from each angle. Shaft oil seal #57 and end bearing bushing # 33
can be removed and replaced at this time, if necessary.
14
34
27
60
9
34
2
19
67
19
33
57
67
7
6
68
68