Ramsey Winch 130K WILDCAT WINCH - Manual (Page 3)

1
RAMSEY HYDRAULIC PLANETARY WINCH MODEL WILDCAT 130K
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and safety
procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until you have carefully
read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch we make.
If the need should arise, warranty procedure is outlined on the back of your self-addressed postage paid warranty card.
Please read and fill out the enclosed warranty card and send it to Ramsey Winch Company. If you have any problems
with your winch, please follow instructions for prompt service on all warranty claims. Refer to back page for limited
warranty.
SPECIFICATIONS*
APPROXIMATE WEIGHT: 2200 LBS
WORKING PRESSURE: 2600 PSI
CABLE DIAMETER: 1.125 INCH
MAX FLOW: 60 GPM
LAYER
OF
CABLE
CABLE
CAPACITY
LOW SPEED HIGH SPEED
LINE PULL LINE SPEED LINE PULL LINE SPEED
Ft m Lb Kg fpm mpm Lb Kg fpm mpm
1 50 15 130000 58960 16 4.8 60000 27210 34 10.3
2 110 33 106300 48210 19 5.8 49000 22220 40 12.1
3 180 54 90000 40820 22 6.6 41500 18820 47 14.2
4 265 80 78000 35380 25 7.6 36000 16320 54 16.4
5 360 109 68800 31200 28 8.5 31700 14370 61 18.5
6 465 141 61500 27890 32 9.7 28400 12880 68 20.6
* These specifications are based on recommended wire rope of 1.125” Extra Improved Plow Steel Cable and a
9.0 cu. in. / Rev. motor.
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.
WARNINGS:
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
CABLE ANCHOR IS NOT DESIGNED TO HOLD LOAD.
BAND BRAKE IS NOT TO BE USED TO HOLD LOAD.