Ramsey Winch 130K WILDCAT WINCH User Manual

Page 19

Text mode
Original mode

ASSEMBLY OF INTERMEDIATE CARRIER

Note: Item Numbers refer to Carrier parts list on page 16

1. Place output carrier #201 on flat clean surface.

2. Press one set of needle bearings #206 into gear #202. Turn gear #202 over.

3. Install spacer #207, and the next needle bearing #206.

4. Slide the gear #202 into position in the output carrier #201.

5. Place thrust washer #203 on top of gear #202. Insert carrier pin #204 into carrier #201

6. Turn output carrier #201 on its side so that the gear #202 is on top.

7. Insert a thrust washer between gear #202 and output carrier #201. Completely insert carrier

pin #204 into carrier #201 using care to align the roll pin hole in carrier pin #204 with the roll
pin hole in the output carrier #201.

8. Drive roll pin #205 into output carrier #201 until roll pin #205 is flush with surface of the output

carrier #201.

9. Repeat steps 1-8 to install the two remaining gears into the output carrier.