Ramsey Winch 130K WILDCAT WINCH - Manual (Page 16)

DISASSEMBLY OF INPUT CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see parts list below). If purchasing individual parts, it will be necessary to
disassemble the input gear carrier as outlined below.
1. Carefully drive roll pin #104 into carrier pin #103 so that it is captured within carrier pin #103
but not touching the opposite side of the input carrier #106.
2. Tap carrier pin #103 to remove it from the input carrier #106.
3. Slide the planet gear #101and the (2) thrust washers #102 from the carrier #106. Bearings
#105 may then be pressed out.
4. Remove the roll pin #104 from the carrier pin #106.
5. Repeat this process for the two remaining gears in the carrier.
106
102
104
103
101
105
102
ITEM # QTY PART # DESCRIPTION
101 3 334225 GEAR-PLANET
102 6 518070 THRUST WASHER
103 3 470130 PIN-CARRIER
104 3 470103 ROLL PIN 1/4 DIA X 1 1/4 LG
105 3 402140 ROLLER
106 1 317026 CARRIER-INPUT
14