Ramsey Winch 130K WILDCAT WINCH - Manual (Page 18)

DISASSEMBLY OF INTERMEDIATE CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see below). If purchasing individual parts, it will be necessary to
disassemble the gear carrier as outlined below.
1. Carefully drive roll pin #205 into carrier pin #204 so that it is captured within carrier pin #204
but not touching the opposite side of the output carrier #201.
2. Tap carrier pin #204 to remove it from the output carrier #201.
3. Slide the planet gear #201and the (2) thrust washers #202 from the carrier #206. Bearings
#205 may then be pressed out.
4. Remove the roll pin #205 from the carrier pin #204.
5. Repeat steps 1-4 for remaining gears.
301
303
306
304
302
307
306
303
305
ITEM QTY PART NO DESCRIPTION
201 1 317025 OUTPUT CARRIER
202 3 334224 PLANET GEAR
203 6 518073 THRUST WASHER
204 3 470129 CARRIER PIN
205 3 470103 ROLL PIN 1/4 DIA X 1 1/4 LG
206 6 402143 BEARING-NEEDLE ROLLER
207 3 362316 SPACER
16