Ramsey Winch 16K Capstan - Manual (Page 7)

INSTRUCTIONS FOR OVERHAUL 16K CAPSTAN
Take note of mounting configurations for proper mounting of parts during re-assembly. Replace all gaskets, o-
rings, and seals during re-assembly.
Disconnect tube (item #40) from elbow fittings (items #20) on bottom of end bearing and counterbalance valve
(item #19). Remove motor (item #11) from end bearing by slowly unscrewing capscrews (items #38). CAUTION:
MOTOR IS UNDER SPRING PRESSURE.
Remove springs (items #18) from pockets and inspect for damage.
Replace gasket (item #17).
Remove coupling and input shaft (item #4 and #5) from end bearing. Examine coupling for signs of wear, replace
if necessary. If necessary, remove counterbalance valve from motor by removing capscrews (items #39).
5
18
40
17
11
38
20
19
39
20
5
4