Ramsey Winch REP-6000/8000/9000 User Manual
Page 6
6
Repositioning Shifter for Specific Bull Bar Applications
Note: The shifter is positioned correctly for most applications. It will only need to be repositioned as
necessary for specific bull bar applications.
Refer to the Parts List and Exploded Parts Diagram for your specific winch elsewhere in this owner’s
manual.
1. Position winch as shown in Figure 6. Remove screws from tiebars. You may be able to loosen the
screws at the motor end without removing them. Pull the Gear Housing assembly from the drum and
shaft and set it down on the work bench with the Gear Housing Cover up. Remove the drum bushing
from the Gear Housing assembly or the end of the drum. Set aside.
2. Remove (6) capscrews
from the Gear Housing
Cover. Holding the Gear
Housing Cover over the
Gear Housing assembly,
flip it over and set it on the
workbench.
3. Gently lift the Gear Housing
assembly, working the gears,
bushings, etc. that are inside the
Gear Housing out so that they are
left stacked on the workbench.
See Figure 8.
4. Turn the Gear Housing assembly
over and set on workbench.
Remove the Retainer (item #37)
by removing six capscrews (item
#21) from Gear End Bearing
(item 13). Once the retainer is
removed, the Ring Gear (item
#10), Cam Ring (item #36), and
Locking Ring (item #34) can be
lifted off the end bearing.
Remove the six springs (item
#38) from the end bearing.
FIGURE 6
FIGURE 8
FIGURE 7