Ramsey Winch REP-6000/8000/9000 - Manual (Page 5)

REP 9000 24V
When mounting winch, connect labeled motor
leads coming from solenoid assembly to appro-
priately marked motor terminals. TIGHTEN NUTS
ON MOTOR TERMINALS. Attach solenoid ground
to #10 Capscrew located on vertical surface of
motor end bearing (See FIGURE 4). Use solenoid
clamp, as shown in FIGURE 2, to secure solenoid
assembly to winch motor. If installing in combo
mounting kit, position at about a 45° angle for
clearance of lower winch guard tube in kit. Be
sure that clamp is clear of motor terminals at bot-
tom of motor. TIGHTEN CLAMP SECURELY.
Attach fairlead to channel using hard-
ware furnished with winch (see FIG-
URE 5). Attach winch to channel.
Place (4) flat washers and nuts into
pockets of winch mounting feet and
thread capscrews with lock washers
through mounting holes in channel and
into hardware in winch feet.
Substitution of attaching hardware
items (bolts, nuts or washers) different
from those supplied with your winch
and mounting kit can lead to failure
causing damage or serious injury (use
SAE grade 5 bolts or better and torque
to 34 ft. lbs.)
Place end of drum cable through fair-
lead and attach cable hook. Use clevis
pin and cotter pin (see FIGURE 5).
5
FIGURE 4
Motor
Terminals
Hole for
Solenoid
Ground Wire
Bolt
FIGURE 5